![Triple Track Bypass Sliding Barn Door Hardware Kit- Inverted Bent Roller Design Triple Track Bypass Sliding Barn Door Hardware Kit- Inverted Bent Roller Design](https://automaticslidingdoorhardware.com/wp-content/uploads/Triple_Track_Bypass_Sliding_Barn_Door_Hardware_Kit_Inverted_Bent_Roller_Design_01_mrg.jpg)
THREE-DOOR FULL BYPASS SYSTEM. A true triple bypass, consists of three individual tracks where each door can slide on its own track independently. All three doors are able to overlap 100% and can slide from one end to the other with no limitations or interference. Triple Bypass would give you an immediate thought of “BIG GAP” bypass system, but our upgraded triple bypass system now has minimal spacing between each doors. For example when a standard door thickness (1-3/8in) is used, the gaps between each door will range from 1 to 1-1/2in. The gap between the front face of the outer door and the wall is now about 8in compared to our previous system which was 11in. Now the doors are close to one another, this brings you optimal privacy without the unpleasant gaps. Our bracket has been upgraded therefore finding bracket hole placements and alligning of tracks are no longer needed. The steps for installation has been reduced due to the brackets being mostly pre-assembled. You will also receive a step by step installation manual with U. Standard measurements, simple instructions and informative diagrams. Compared to our double track bypass and our previous triple bypass, this system offers a bigger available opening. For example if our triple bypass is applied in a setup with no available wall space, this hardware provides 2/3 of the opening size once the doors are stacked and pushed to one side. VARIOUS TRACK LENGTHS AND FULL SIZES. While other brands only offer few selected track lengths, we offer anywhere from 4ft up to 20ft. The spacing between each pre-drilled holes on the track is 16in apart to match your studs. Our tracks 7.5ft and shorter all come as one full piece. 8ft and longer will come as two or more pieces joined with a junction plate. Thus the middle section where two tracks join may not be 16in apart. A header board will be required if the holes on the track do not line up with your studs.